Set Up Webhook Notification
This section describes how to set up Webhook notification.
Prerequisites
WhizardTelemetry Notification should have been installed and enabled.
You should get the access parameters for the Webhook in advance. For more information, please contact your Webhook administrator.
Steps
Log in to the KubeSphere web console.
Click the current username in the upper-right corner of the page, and then select Notification Settings from the drop-down list.
On the Notification Settings page, under the Webhook tab, set the Webhook notification parameters, and then click OK.
Server Settings
Parameter Description Webhook URL
The access URL for the Webhook.
Authentication Type
The authentication type for the Webhook.
No Authentication: No authentication is required.
Bearer Token: Use a URL Bearer token for authentication. If you choose this type, you need to further set the token used for authentication.
Basic Authentication: Use a username and password for authentication. If you choose this type, you need to further set the username and password used for authentication.
Skip TLS Verification (Insecure)
Whether to skip TLS verification when calling the Webhook.
Filter Conditions
The notifications sent by KubeSphere are presented in the form of key-value pairs. When the key and value filled in here match the key and value in the label settings of the alert rules in rule groups, the notifications can be filtered by labels and alert notifications that meet specific label conditions can be sent to receivers. Click Add to set multiple conditions.
Parameter Description Key
The key in the notification content. Click the dropdown list to select a preset key, or input a custom key in the dropdown list.
Operator
The operator for the filter condition.
Contains: The value corresponding to the key contains a specific string.
Does Not Contain: The value corresponding to the key does not contain a specific string.
Exists: The specific key exists in the notification content.
Does Not Exist: The specific key does not exist in the notification content.
Regex Match: Filter notifications that meet the conditions through a regular expression.
Values
The value corresponding to the key must include the specified string. Press Enter to set multiple strings. If the value corresponding to the key contains any of these strings, the condition is met.
Click Send Test Message to confirm that the notification channel is working properly.
Click the Notification Disabled switch at the top to enable Webhook notification.
Feedback
Was this page Helpful?
Receive the latest news, articles and updates from KubeSphere
Thanks for the feedback. If you have a specific question about how to use KubeSphere, ask it on Slack. Open an issue in the GitHub repo if you want to report a problem or suggest an improvement.
Previous
What’s on this Page